WOODS 1050 BACKHOE Attachment for Type 2 or larger tractor, 6K lbs digging force

Description

This listing is for a
Woods Backhoe
attachment
Model 1050
.  This used item has been well-maintained and is in very good condition, but does show wear that it has been used on a farming property (
see photos
).  The backhoe attachment is stored inside when not in use.  The owner claims that it is perfect for many different “around the farm” digging jobs.  The seat is weathered, but easily replaceable.
It is currently attached to a 62 hp tractor and was tested.  It runs smoothly and an inspection showed
no
cracks, rotting or hydraulic leaks from the cylinders or hoses.
Both the
Dipper cylinder
and
Bucket cylinder
were rebuilt.  The Dipper rod has been replaced and the Bucket rod was re-chromed.  The seals on these units have been replaced.
Both a 12” and a 24” digging bucket will be provided with this unit (
see photos
).  Both have been well maintained, have all of the teeth and the 12” bucket still has the side decals.
A complete pdf copy of the
Woods Backhoe 1050
Owner's Manual
(the July 7, 2006 revision version) will be provided to the buyer.  This manual has listed specifications, performance standards, safety warnings, dealer service information, identified parts list for replacement, trouble-shooting charts, operation checks & diagrams and much more.
Specifications of the
Woods BH1050
:
Per the owner’s manual, this backhoe should only be used with a Category 2 or 3 tractor.  Specifically, the owner's manual states under the Mounting Section:
“Only mount on Category “2” or “3” tractors with 2000 lb. minimum lift capacity and with original equipment high-strength top link pin of at least 1” diameter or approved top link brackets and pins available from your Woods Dealer for some tractors not originally equipped with 1” diameter pins.”
This Backhoe attachment has its own PTO pump and does not use the hydraulics of the tractor
This Backhoe attachment has:
a maximum reach of 157”
a maximum operating height of 148”
a maximum digging depth of 127”
a transportation height of 95”
The Stabilizers have a 2.5” bore with a 15” stroke.  They measure 83” wide when up and 113” when down.
The Bucket cylinder has a 2.5” bore with a 28” stroke and provides a digging force of 6000 lbs.
The Dipperstick cylinder has a 3” bore with a 27” stroke and a digging force of 2863 lbs.
The Lift cylinder has a 3” bore with a 27” stroke.
This Woods 1050 Backhoe is for
Pick-up Only
and is located about twenty miles south of Clarion, PA.  Specific details of item transportation requirements will be provided after notification of payment has been received.
Please contact me if you have any questions.